Connect to 3D printer SK1

Jump to bottom

Mark edited this page Nov 19, 2024 · 7 revisions

1, Connect the BDsensor to the toolhead board as showing picture.

Mainboard config

2, Update the Klipper

Update the klipper to the latest
Install the BDsensor software
Compile the klipper and firmware
Flash the firmware
Configure the printer.cfg

Reference link :

https://github.com/markniu/Bed_Distance_sensor/wiki/Installing-for-Klipper

https://github.com/tomsbasement/twotrees-sk1

https://wiki.twotrees3d.com/en/3DPrinterSeries/SK1/Firmwarerefreshtutorial

and also don't forget to recalibrate the BDsenor after switch to different printer.

3, Test video: https://youtu.be/cOoGJNGE2v0